SMX-30 Plus 18kg

SMX 30PLUS

Add to quick access

Hybrid polymer timber flooring adhesive

SMX®-30 Plus parquet adhesive is an ultra high strength, fast setting, tough, but flexible adhesive for full surface bonding of all types of timber floors. Based on Soudal's SMX hybrid polymer technology, free of solvents, water and isocyanates. Extreme bond strength, especially suited for the bonding of wide massive timber planks onto all types of subfloors, both porous and non-porous. Very low emission rate (EC-1 Plus).

Open technical data sheet

Shown product

SMX-30 Plus 18kg

Other product variants

What are you looking for?

Featured properties

  • Ready to use, no mixing required
  • Remains flexible
  • Single component ready to use system
  • EC-1 Plus label: very low emission values
  • Solvent free
  • Contains no water
  • Free of isocyanates
  • Easy to apply
  • Forms stable peaks when applied with a notched trowel or spreader comb
  • Rapid cure and build up of final bond strength
  • High final bond strength (according to EN14293)
  • Remains permanently elastic
  • Suitable for subfloor heating
  • Avoids staining of the hands

Applications

  • SMX®-30 Plus is a solvent, and water-free universal parquet adhesive based upon SMX Polymers.
  • Suitable for indoor bonding of all types of wooden floors such as solid, stab, pre-finished, and on-end parquet, wood-planks up to 20cm wide, wood-block and laminates.
  • Suitable for use on porous and non-porous substrates such as mosaic, anhydrite, concrete, screeds, wood, chipboard and OSB Board (large particle size chipboard) , including floors with underfloor heating.
  • SMX®-30 Plus is also extremely suitable for bonding moisture sensitive wood onto moderately porous surfaces.

Instructions

  • Apply the adhesive to the surface by means of notched SOUDAL trowel N°11. Do not apply more to the surface than can be covered with parquet within 40 minutes. Slide the parquet onto the adhesive layer and tap into place or tamp down with a rubber hammer. A minimum of 80% contact coverage is required to ensure a perfect adhesion. Loading the parquet with weights will improve the final bond strength. Wait at least 12 hours before sanding and finishing the parquet. ..