MS-20PLUS
Add to quick accessHybrid polymer timber flooring adhesive
High quality trowelable, hybrid polymer based parquet adhesive. Free off isocyanates, solvents and water. For bonding many types of parquet onto indoor substrates. Ready to use, no mixing required. Rapid cure and strength build up - load bearing after 8 hours, sandable after 24 hours. Bond strength more than 1.2N/mm².
Featured properties
- Hybrid polymer parquet adhesive
- Ready to use, single component
- EC-1 PLUS - very low emission
- Solvent and isocyanates free
- Easy to apply
- Forms stable peaks when applied with a notched trowel
- Rapid cure and build up of final bond strength
- Suitable for underfloor heating
Assets
TDS Soudal, MS-20PLUS, English
Applications
- Suitable for bonding all types of wooden floors; solid, stab, pre-finished, on-end parquet, wood plank, wood-block and laminates. Ideal for use on porous and non-porous substrates such as mosaic, anhydrite, concrete, screeds, wood, chipboard and OSB Board, including floors with underfloor heating and cooling.
Example of Applications
Instructions
- Apply the adhesive to the surface by means of notched SOUDAL trowel N°11. For parquet sizes smaller than 60mm wide and 300mm long notched SOUDAL trowel N°3 is recommended. Do not apply more to the surface than can be covered with parquet within 30 minutes. Slide the parquet onto the adhesive layer and tap into place or tamp down with a rubber hammer. A minimum of 80% contact coverage is required to ensure a perfect adhesion. Loading the parquet with weights will improve the final bond strength. Wait at least 24hrs before sanding and finishing the parquet.
Accessories
